Vfi (Vpls) - Cisco ASR 9000 Series Reference Manual

vfi (VPLS)

vfi (VPLS)
To configure virtual forwarding interface (VFI) parameters and to enter L2VPN bridge group bridge domain
VFI configuration mode, use the vfi command in L2VPN bridge group bridge domain configuration mode.
To remove all configurations that are made under the specified VFI, use the no form of this command.
vfi vfi-name
no vfi vfi-name
Syntax Description
vfi-name
Command Default
None
Command Modes
L2VPN bridge group bridge domain configuration
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vfi command to enter L2VPN bridge group bridge domain VFI configuration mode.
Task ID
Task ID
l2vpn
Examples
The following example shows how to create a VFI:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
380
Name of the specified virtual forwarding interface.
Modification
This command was introduced.
Operations
read, write
Multipoint Layer 2 Services Commands