Operating Mode Switch Actuator - ABB SA/S 12.16.6.1 Product Manual

®
ABB i-bus KNX
3.2.3 Operating mode
Switch Actuator
60 2CDC 505 056 D0207 | SA/S
Commissioning
The operating mode Switch Actuator is used for normal switching, e.g. of
lighting. The output is controlled via various logic, time and safety functions.
The input signal for the function is received via communication object
Switch. The Switch Actuator carries out the function independently and
controls the corresponding relay.
The comprehensive range of additional functions available is described in
this chapter.
Status response of switching state
Object "Status Switch"
Options: no
after a change
always
This parameter can enable the communication object Status Switch. This
contains the current switching state and the present contact position.
•
no: The switch state is updated but the status is not actively sent on
the bus.
• after a change: With a change of the switch state, the status is
actively sent on the bus via the communication object Status Switch.
This can have a major affect on the bus load on a Switch Actuator
with several outputs.