Conversion Of Previous Application Program Versions; Conversion Options - ABB SA/S 12.16.6.1 Product Manual

®
ABB i-bus KNX
3.1.1 Conversion of previous
application program
versions
3.1.1.1

Conversion options

Device type
source device
SA/S 2.16.5S
SA/S 4.16.5S
SA/S 8.16.5S
SA/S 12.16.5
SA/S 2.20.1S
SA/S 4.20.1S
SA/S 8.20.1S
SA/S 12.20.1
SA/S x.16.6.1
SA/S x.16.5.1
Commissioning
®
For ABB i-bus KNX devices from ETS3 or higher, it is possible to assume
the parameter settings and group addresses from earlier application
programs.
Note
Default values are set for newly added parameters after conversion.
The following application programs can be converted:
Application name
Convertible to
source device
Switch 2f 16CS/2.0
Switch 4f 16CS/2.0
Switch 8f 16CS/2.0
Switch 12f 16C/2.0 non-convertible
Switch 2f 20S/2.0
Switch 4f 20S/2.0
Switch 8f 20S/2.0
Switch 12f 20A/2.0 non-convertible
Switch xf 16CS/3.0,
3.1 or 3.2
Switch xf 16C/3.1 or
3.2
Note
If the number of outputs of the target device is larger than the number of
outputs of the source device, only the first outputs of the target device are
written with the converted data of the source device. The remaining
outputs retain the default values or are reset to the default values.
Device type target device
SA/S x.16.6.1
SA/S x.16.6.1
SA/S x.16.6.1
SA/S x.16.6.1
SA/S x.16.6.1
SA/S x.16.6.1
SA/S x.16.6.1
SA/S x.16.5.1
SA/S x.16.6.1
SA/S x.16.5.1
SA/S | 2CDC 505 056 D0207 47
Application name target
device
Switch xf 16CS/3.2
Switch xf 16CS/3.2
Switch xf 16CS/3.2
Switch xf 16CS/3.2
Switch xf 16CS/3.2
Switch xf 16CS/3.2
Switch xf 16CS/3.2
Switch xf 16C/3.2
Switch xf 16CS/3.2
Switch xf 16C/3.2