Parameters - ABB SA/S 12.16.6.1 Product Manual

®
ABB i-bus KNX
3.2

Parameters

54 2CDC 505 056 D0207 | SA/S
Commissioning
The parameterization of the Switch Actuator is implemented using the
Engineering Tool Software ETS from version ETS2 V1.3 or higher.
The application program can be found in the ETS2 / ETS3 at
ABB/Output/Binary output/Switch xf 6A/2, xf 10A/2, xf 16A/2, xf 16C/2 or xf
16CS/3.
The following chapter describes the parameters of the Switch Actuators
using the parameter window. The parameter window features a dynamic
structure, so that further parameters may be enabled depending on the
parameterization and the function.
The default values of the parameters are underlined,
e.g.
Options: yes
no
Note
In this product manual, all the current 2/4/8 and 12-fold Switch Actuators
are described. These devices each have 2/4/8 or 12 outputs. However, as
the functions for all outputs are identical, only the functions of output A will
be described.
Should the details in the product manual refer to all outputs, 2-fold
corresponds to outputs A...B, 4-fold corresponds to outputs A...D, 8-fold
corresponds to outputs A...H and 12-fold corresponds to outputs A...L,
the designation outputs X is used.
The variants with current detection feature an additional parameter page
as well as additional communication objects for this function.