Resetting The Terminal; Hard Reset (Cold Boot); Soft Reset (Warm Boot) - Honeywell Dolphin 75e User Manual

Preliminary Draft, Not for Release - Please Review 2-3-2015
3. Pull the battery latch back and remove the battery.
Battery Latch
4. Insert the new battery and install the battery door.
5. Apply pressure to the edges of the battery door to ensure the door is properly closed. Engage the door lock.
6. Press the Power button
Important: All battery and connector doors must be present, undamaged, and properly closed to maintain the environmental
rating of the terminal.

Resetting the Terminal

There are two three types of system resets: a Hard Reset, a Soft Reset, or a Factory Reset. The hard or soft reset preserves
all data stored in the file system. Contact a Honeywell technical support representative for information on how to perform a
Factory Reset. For contact information, see

Hard Reset (Cold Boot)

A hard reset reboots the device and closes any open applications running in RAM at the time of the reset.
1. Press and hold the Power button
Note: If the Show System Dialog setting is turned off (see page 6-1), the Options menu does not display when you
press and hold the Power button. The terminal automatically reboots when Power button is held for approximately
8 seconds.
2. Touch Reboot.

Soft Reset (Warm Boot)

A Soft Reset (Warm Boot) re-boots the device and preserves any objects created in RAM. You would perform a soft reset
when: the terminal fails to respond, after installing some software applications, or after making changes to certain system
settings, such as network cards.
Press and hold the Power button
complete, the Lock screen displays.
.
Technical Assistance
until the Options menu displays.
f
or approximately 8 seconds until the terminal starts to reboot. When the reset is
on page 14-1.
2 - 11