Troubleshooting - D-Link DCS-900 Quick Installation Manual

Troubleshooting

1. How do I configure my DCS-900 without the CD?
• Connect your DCS-900 to the network using an Ethernet cable.
• Log on to www.dlink.eu, choose your local country. Download the Setup Wizard utility
from the DCS-900 section under technical support.
• Install and run Setup Wizard utility.
Either use the Wizard included in the utility to configure the device or click on Link to
access the devices directly.
• The default username is ' ' (leave the field blank). The default password is ' ' (leave the
field blank).
• If you have changed the password and can not remember it, you will need to reset the
DCS-900 to set the password back to ' ' (leave the field blank).
If the DCS-900 cannot find a DHCP server, the default IP address is http://192.168.0.20.
2. How do I reset my DCS-900 to factory default settings?
• Ensure the DCS-900 is powered on.
• Push and hold a paperclip in the reset hole for 10 seconds, then release it. The camera
should be back to factory default settings.
Note: Resetting the DCS-900 to factory default will erase the current configuration settings.
To re-configure your settings, please rerun D-Link Clink'n Connect CD or access the device
via procedures described in question 1.
3. If I don't have a router, how do I install the camera?
• Connect the camera directly to the computer's Ethernet port
• You need to assign your computer a static IP address in range with the camera, such as
192.168.0.1.
• You can then access and setup the device via the default IP address of
http://192.168.0.20.
4. What can I do if my DCS-900 is not working correctly?
• Check the LED's on the front of the DCS-900. The Power LED should be on and the LAN
LED should flash.
• Check that all the cables are firmly connected at both ends.
• Power the DCS-900 off for 20 seconds, and then power it back on.
Technical Support
Thank you for choosing D-Link products. For further information, support, product drivers and manuals,
please visit the D-Link website at www.dlink.eu.
Your camera should be detected automatically.
www.dlink.co.uk
: 08456 12 0003
3