Troubleshooting; Setup And Configuration Problems - D-Link DCS-2103 Quick Installation Manual

TrOUbLESHOOTING

SetuP aND CoNFIGuratIoN ProbLemS

1. HOw DO I rESET my DCS-2103 TO FACTOry DEFAULT SETTINGS?
- ensure the dcs-2103 is powered on.
- push and hold a paperclip in the reset hole for 10 seconds, then release it. the camera will then
reset to factory default settings.
2. HOw DO I CONFIGUrE my DCS-2103 wITHOUT THE CD?
- connect your pc to the router using an ethernet cable.
- log on to d-link support site http://support.dlink.com.tw. download the setup Wizard se utility
from the dcs-2103 section under technical support.
- Install and run setup Wizard utility se.
- the default username is 'admin'. the default password is blank.
- If you have changed the password and can not remember it, you will need to reset the dcs-
2103 to set the password back to blank (leave the field blank). If the dcs-2103 cannot find a
dHcp server, the default Ip address is http://192.168.0.20.
3. wHAT CAN I DO IF my DCS-2103 IS NOT wOrKING COrrECTLy?
- try using the wizard on the included cd.
- to make sure your hardware is installed correctly, make sure that:
• the front led is lit solid green
• your Internet connection is working
• your router's lan & Wan connections are ok
• your router supports upnp
• your camera is on the same network as your pc
• both your pc and camera have a working Internet connection
- If your camera is still not working, check your router and make sure it is using the latest
firmware.
4. I DO NOT HAvE A rOUTEr. HOw DO I INSTALL my DCS-2103?
- connect the camera directly to the computer's ethernet port.
- assign your computer a static Ip address within the same range as the camera, such as
192.168.0.x.
- access and set up your camera via the default Ip address of http://192.168.0.20.
- For more information, please refer to the user manual.
4
®
DCS-2103