Configuring The Rest Api Local Port And Autosave Options - Cisco CSR 1000v Series Software Configuration Manual

Enabling Management by REST API
Command or Action
Step 13
guest ip address remote-mgmt-ipv4-addr
Example:
router(config-virt-serv-intf)# guest ip address
172.25.29.236
Step 14
exit
Example:
router(config-virt-serv-intf)# exit
Step 15 end
Example:
router(config-virt-serv)# end
Step 16 ip route ipaddress subnetmask virtualportgroup
virtualportgroupnumber
Example:
router(config)# ip route 172.25.29.236
255.255.255.255 VirtualPortGroup0

Configuring the REST API Local Port and AutoSave Options

Beginning with Cisco IOS XE 3.13S, you can configure the REST API local port and autosave options.
SUMMARY STEPS
1. remote-management
2. restful-api local-port local-port-number
3. restful-api autosave interval
DETAILED STEPS
Command or Action
Step 1 remote-management
Example:
router(config)# remote-management
Configuring the REST API Local Port and AutoSave Options
Purpose
Configures the remote-management IP address for the vNIC
gateway interface for the virtual services container.
Exits virtual services interface configuration mode and
enters virtual services configuration mode.
Exits virtual services configuration mode and enters global
configuration mode.
Creates an IP route that maps to the virtual port group. Use
the same IP address that was configured using the guest ip
address command.
Purpose
Enters remote-management configuration mode.
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
283