Below are the main menu selections. For details refer to the VISTA-128FBPN Programming Guide.
MAIN MENU
ZONE PROG?
1 = YES 0 = NO
0
EXPERT MODE?
1 = YES 0 = NO
0
REPORT CODE PROG?
1 = YES 0 = NO
0
ALPHA PROG?
1 = YES 0 = NO
0
DEVICE PROG?
1 = YES 0 = NO
0
OUTPUT PGM?
1 = YES 0 = NO
0
RLY VOICE DESCR?
1 = YES 0 = NO
0
CUSTOM INDEX ?
1 = YES 0 = NO
0
ACCESS POINT PGM
1 = YES 0 = NO
0
ACCESS GRP PGM
1 = YES 0 = NO
0
EVENT/ACTION PGM
1 = YES 0 = NO
0
OPTIONS
For programming the following:
•
Zone Number
•
Zone Response Type
•
Partition Number for Zone
•
Dialer report code for zone
•
Input Device Type for zone (whether RF, polling loop, etc.)
•
Enrolling serial numbers of 5800 Series transmitters and serial polling loop devices into the system.
•
Zone Attributes (e.g., Arm w/Fault, Silent, etc.).
Same as Zone Programming except:
•
Done with a minimum number of keystrokes.
•
Can program wireless keys using pre-defined templates.
NOTE: All the zone attributes cannot be programmed using the Expert Mode.
For programming the following:
•
Alarm report codes for zones
•
Restore and supervisory codes
•
All other system report codes
For entering alpha descriptors for the following:
•
Zone Descriptors
•
Default Screen
•
Custom Words
•
Partition Descriptors
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881ENHC), output relay modules (4204/4204CF), and communication devices (7845i-ent, 7845i-GSM, and
7845-GSM):
•
Device Address
•
Device Type
•
Keypad Options (including Partition assignment)
•
RF House ID
•
Communications device
For defining output device functions.
Must be set to "0".
Must be set to "0".
Must be set to "0".
Must be set to "0".
Must be set to "0".
Options (including Programming Communicator)
Section 4 – Programming
4-3