Figure 8-5 Configuring The Static Route; Figure 8-6 Creating An Interface Named Tunnel1 - Huawei EGW2100 Web Configuration Manual

8 Configuration Example of the VPN
11. Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
12. Choose Security > Packet-Filter. The Packet-Filter page is displayed.
13. Click MORE in the trust-untrust row. The Packet-Filter Config page is displayed. Select
14. Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
15. Click Save on the upper right of the page to save the configuration.
Step 2 Configure the IP addresses of interfaces of the EGW2100 B and add the interfaces to related
security zones.
1.
2.
3.
4.
8-4

Figure 8-5 Configuring the static route

to complete the configuration.
the permit option button respectively next to Inbound Default Packet-filter and
Outbound Default Packet-filter.
to complete the configuration.
NOTE
The default Packet-Filtering rule that allows all the packets to pass may cause security troubles.
Therefore, it is recommended to apply the ACL rule between security zones.
Choose NetWork > Interface. The Interface page is displayed.
Click New. The Create New Interface page is displayed. Configure the parameters as
shown in Figure 8-6.

Figure 8-6 Creating an interface named Tunnel1

Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
Click MORE in the Tunnel1 row. The Interface Configuration page is displayed.
Configure the parameters as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 8-7.
HUAWEI EGW2100
Web Configuration Guide
Issue 01 (2010-02-20)