Figure 4-8 Configuring The Static Route; Figure 4-9 Configuring The Nat - Huawei EGW2100 Web Configuration Manual

HUAWEI EGW2100
Web Configuration Guide
1.
2.
3.
Step 7 Configure NAT.
1.
2.
3.
4.
Step 8 Configure the DHCP function, which can dynamically assign IP addresses to intranet users.
1.
Issue 01 (2010-02-20)
Choose NetWork > Route Config. The Route Config page is displayed.
Click the Route-Static tab. Click New. The Route-Static Config page is displayed.
4-8 shows the parameter setting.

Figure 4-8 Configuring the static route

Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
Create ACL 3001 and configure the rule for ACL 3001: Match all IP packets.
For the configuration procedure, see
Choose Service > NAT > Nat-Policy. The Nat-Policy page is displayed.
Select NAT-Policy tab. Click New. The NAT-Policy page is displayed.
the parameter setting.

Figure 4-9 Configuring the NAT

NOTE
When selecting the ACL, you can select basic ACL or advanced ACL from the drop-down list.
Then select the proper ACL in the ACL classification table.
Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
Choose Service > DHCP > DHCP Basic. The DHCP Basic Config page is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Internetworking
3 Configuration Example of the Basic
Figure
Operation.
Figure 4-9 shows
4-5