Huawei EGW2100 Web Configuration Manual page 44

4 Configuration Example of the Internetworking
5.
6.
7.
8.
9.
10. Click New to enter the Area Config interface.
11. Click Add to add the 172.10.0.0/16 network segment to area 0.
12. Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
13. Click New to enter the Area Config interface.
4-20
CAUTION
The default packet filtering rule that allows all the packets to pass may cause security
troubles. Therefore, it is recommended to apply the ACL rule in interzones.
Choose NetWork > OSPF to enter the OSPF interface.
Click the Process Config tab.
Click New to enter the Process Config interface.
Figure 4-38 Configuring process 100
NOTE
Router ID in the diagram is the router ID that uniquely identifies a router in the OSPF protocol.
Click Apply. Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
Click MORE corresponding to 100 and choose the Area Config tab.
Figure 4-39 Configuring area 0
to complete the configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
HUAWEI EGW2100
Web Configuration Guide
Figure 4-38 shows the parameter setting.
Figure 4-39 shows the parameter setting.
Figure 4-40 shows the parameter setting.
Issue 01 (2010-02-20)