Power Inline Usage-Threshold - Cisco Small Business 300 1.1 Series Administration Manual

Power over Ethernet (PoE) Commands
78-20269-01 Command Line Interface Reference Guide
no power inline priority
Parameters
•
critical—Specifies that the powered device operation is critical.
•
high—Specifies that the powered device operation is high priority.
•
low—Specifies that the powered device operation is low priority.
Default Configuration
The default configuration is set to low priority.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets the inline power management priority of
gigabitethernet port 4 to High.
Console(config)#
interface gi4
Console(config-if)#
23.3

power inline usage-threshold

Use the power inline usage-threshold Global Configuration mode command to
configure the threshold for initiating inline power usage alarms. Use the no form of
this command to restore the default configuration.
Syntax
power inline usage-threshold
no power inline usage-threshold
Parameters
percent—Specifies the threshold in percent to compare to the measured power.
(Range: 1–99)
Default Configuration
The default threshold is 95 percent.
power inline priority high
percent
23
299