Advanced Fcip Interface Configuration; Configuring Peers - Cisco MDS 9000 series Configuration Manual

Chapter 2 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 1
switch(config-profile)# tcp
send-buffer-size 5000
switch(config-profile)# no tcp
send-buffer-size 5000
Displaying FCIP Profile Configuration Information
Use the show fcip profile command to display FCIP profile configuration information.
switch# show fcip profile 7
FCIP Profile 7

Advanced FCIP Interface Configuration

This section describes the options you can configure on an FCIP interface to establish connection to a
peer and includes the following topics:
•
•
•
•
•
•
To establish a peer connection, you must first create the FCIP interface and enter the config-if submode.
To enter the config-if submode, follow these steps:
Command
Step 1
switch# config terminal
Step 2
switch(config)# interface fcip 100

Configuring Peers

To establish an FCIP link with the peer, you can use the peer IP address option. This option configures
both ends of the FCIP link. Optionally, you can also use the peer TCP port along with the IP address.
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Internet Address is 47.1.1.2 (interface GigabitEthernet4/7)
Listen Port is 3225
TCP parameters
SACK is disabled
PMTU discovery is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Send buffer size is 0 KB
Maximum allowed bandwidth is 1000000 kbps
Minimum available bandwidth is 15000 kbps
Estimated round trip time is 1000 usec
Configuring Peers, page 2-17
Assigning a Peer IP Address, page 2-18
Configuring Active Connections, page 2-18
Enabling Time Stamp Control, page 2-19
B Port Interoperability Mode, page 2-19
Quality of Service, page 2-22
Purpose
Configure the advertised buffer size to 5000 KB. The valid
range is from 0 to 16384 KB.
Reverts the switch to its factory default. The default is 0 KB.
Purpose
Enters configuration mode.
Creates an FCIP interface (100).
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
Configuring FCIP
2-17