Displaying Global Iscsi Information; Displaying Iscsi Sessions - Cisco MDS 9000 series Configuration Manual

Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Displaying Global iSCSI Information

Use the show iscsi global command to view the overall configuration and the iSCSI status. See
Example
Example 4-6
switch# show iscsi global
iSCSI Global information
Authentication: CHAP, NONE
Import FC Target: Enabled
Initiator idle timeout: 300 seconds
Number of target node: 0
Number of portals: 11
Number of session: 0
Failed session: 0, Last failed initiator name:

Displaying iSCSI Sessions

Use the show iscsi session command to view details about the current iSCSI sessions in the switch.
Without parameters, this command displays all sessions. The output can be filtered by specifying an
initiator, a target, or both.
Example 4-7
(iqn.1987-05.com.cisco:02.3021b0f2fda0.avanti12-w2k) and another based on its IPv4 address
(10.10.100.199).
Example 4-7
switch# show iscsi session
Initiator iqn.1987-05.com.cisco:02.3021b0f2fda0.avanti12-w2k
Initiator ip addr (s): 10.10.100.116
Session #1
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
4-34
Configured TCP parameters
Local Port is 3260
PMTU discover is enabled, reset timeout is 3600 sec
Keepalive-timeout is 60 sec
Minimum-retransmit-time is 300 ms
Max-retransmissions 4
Sack is disabled
QOS code point is 0
Forwarding mode: pass-thru
TMF Queueing Mode : disabled
Proxy Initiator Mode : enabled
nWWN is 11:11:11:11:11:11:11:11 (manually-configured)<----User-assigned nWWN
pWWN is 22:22:22:22:22:22:22:22 (manually-configured)<----User-assigned pWWN
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
iSCSI statistics
Input 7 packets, 2912 bytes
Command 0 pdus, Data-out 0 pdus, 0 bytes
Output 7 packets, 336 bytes
Response 0 pdus (with sense 0), R2T 0 pdus
Data-in 0 pdus, 0 bytes
4-6.
Displays the Current Global iSCSI Configuration and State
displays one iSCSI initiator configured based on the IQN
Displays Brief Information of All iSCSI Sessions
Discovery session, ISID 00023d000043, Status active
Chapter 4 Configuring iSCSI
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)