Cisco MDS 9000 series Configuration Manual page 169

Chapter 4 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 4-2
Parameters
Number of TCP connections
minimum-retransmit-time
keepalive-timeout
max-retransmissions
PMTU discovery
pmtu-enable reset-timeout
SACK
max-bandwidth
min-available-bandwidth
round-trip-time
Buffer size
Control TCP and data connection
TCP congestion window monitoring
Burst size
Jitter
TCP connection mode
Fibre Channel targets to iSCSI
Advertising iSCSI target
iSCSI hosts mapping to virtual Fibre
Channel hosts
Dynamic iSCSI initiators
Identifying initiators
Advertising static virtual targets
iSCSI login authentication
revert-primary-port
Header and data digest
iSNS registration interval
iSNS registration interval retries
Fabric distribution
Table 4-3
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Default iSCSI Parameters
lists the default settings for iSLB parameters.
Default
One per iSCSI session
300 msec
60 seconds
4 retransmissions
Enabled
3600 sec
Enabled
1 Gbps
70 Mbps
1 msec
4096 KB
No packets are transmitted
Enabled
50 KB
500 microseconds
Active mode is enabled
Not imported
Advertised on all Gigabit Ethernet interfaces,
subinterfaces, PortChannel interfaces, and PortChannel
subinterfaces
Dynamic mapping
Members of the VSAN 1
iSCSI node names
No initiators are allowed to access a virtual target (unless
explicitly configured)
CHAP or none authentication mechanism
Disabled
Enabled automatically when iSCSI initiators send
requests. This feature cannot be configured and is not
available in store-and-forward mode.
60 sec (not configurable)
3
Disabled
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
Default Settings
4-97