NETGEAR Arlo Baby User Manual page 79

Recalibrate the Air Sensors
If you move your Arlo Baby to a new location, you might notice that you receive
more alerts than usual due to different temperature, humidity, and air quality in the
camera's new location.
If you recently moved your Arlo Baby to a new location and you are receiving too
many alerts, you can power cycle your Arlo Baby to recalibrate the sensors so that
they adjust to the new location and you receive fewer alerts.
¾ To recalibrate your Arlo Baby's sensors:
1. Unplug your Arlo Baby's power adapter.
2. If your Arlo Baby's LED is still on, turn off battery power using the switch on the
bottom of your Arlo Baby.
3. Wait ten seconds, then plug Arlo Baby back in or turn battery power back on.
Your Arlo Baby's sensors recalibrate over the next 24 hours.
4. If you are still receiving too many alerts, change your notification settings and
alert thresholds from the Devices tab of the Arlo app.
For information about air sensors, see Air Sensors on page 30.
79