Firmware Upgrade - GE IC755CxS06RDx User Manual

This utility operates similar to
the QuickPanel + Update Tool,
which comes with the OS
image upgrade binaries. The
operator can continue to use
the QuickPanel + Update Tool
to use the DIP Switch feature.
30 GFK-2847R
For public disclosure

3.9.1 Firmware Upgrade

The Firmware Upgrade utility setting enables operators to upgrade the firmware.
Firmware updates are not supported over Ethernet or Serial interfaces. Insert the media
(SD Card) containing the required files for firmware upgrade and perform the following
procedure.
Note Make sure the copy of required binaries to the SD card is not within a folder.
Note The firmware package contains encrypted .nbo files. Use the PreUpdate.exe tool to
decrypt the .nbo files before using them for upgrade.
After a firmware upgrade, which refreshes the device fresh, the user must download the
project again and install their own tools (including third party tools) on the device.
Note It is recommended that the user back up any important data prior to firmware
upgrade so that they can replace the data after firmware upgrade if necessary.
Attention
➢ ➢ To perform a firmware upgrade
From the Start menu, select Programs, System, and QuickPanel
1.
Settings Tool to display the QuickPanel
2. Upgrade the firmware.
If the current firmware build version on the
QuickPanel + is any of the following, refer to the
section Firmware Upgrade for Specific Build
• Build 3 or below for IC755CxS06RDx
(6" Display)
• Build 23 or below for IC755CxW07CDx
(7" Display)
• Build 14 or below for IC755CxS10CDx
(10" Display), IC755CxS12CDx
(12" Display), and IC755CxS15CDx
(15" Display)
+
OS Utilities Settings window.
QuickPanel⁺ Operator Interface User Manual
Version:
+ OS Utilities