Dlp- G205 Change Optical Line Threshold Settings For Opt-Pre And Opt-Bst Amplifiers - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Change DWDM Card Settings
Table 11-9
Parameter
Port
Power Failure
Low (dBm)
Power Degrade
High (dBm)
Power Degrade
Low (dBm)
VOA Degrade
High (dBm)
VOA Degrade
Low (dBm)
Click Apply. If the change affects traffic, a warning message displays. Click Yes to complete the
Step 6
change.
Return to your originating procedure (NTP).
Step 7
September 2005
DLP-G205 Change Optical Line Threshold Settings for OPT-PRE and OPT-BST Amplifiers
OPT-PRE and OPT-BST Card Optical Channel Alarm Threshold Settings
Description
(Display only) Displays the port number. —
Shows the optical power failure low
threshold for the port. The threshold is
calculated automatically when you run
ANS. You can manually change the
threshold. The value must be within the
optical power range that is specified for
the card. (See Appendix B, "Hardware
Specifications.")
For OPT-BST cards, this parameter
applies to Port 2 (Output COM) and Port
4 (Output OSC) are related to Optical
Safety mechanism at DWDM Network
layer (see Chapter 16: "16.4 Network
Optical Safety - Automatic Laser
Shutdown" for a detailed description).
Does not apply to OPT-BST and
OPT-PRE line parameters.
Does not apply to OPT-BST and
OPT-PRE line parameters.
Does not apply to OPT-BST and
OPT-PRE line parameters.
Does not apply to OPT-BST and
OPT-PRE line parameters.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Options
Numeric.
Numeric.
Numeric.
—
—
11-15