Figure - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 2 Connect the PC and Log into the GUI
i.
j.
Return to your originating procedure (NTP).
Step 7
DLP-G42 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Log into the workstation as the root user.
Step 2 Check to see if the interface is plumbed by typing:
# ifconfig device
For example:
# ifconfig hme1
•
•
Step 3 Plumb the interface by typing:
# ifconfig device plumb
For example:
# ifconfig hme1 plumb
Configure the IP address on the interface by typing:
Step 4
# ifconfig interface ip-address netmask netmask up
For example:
# ifconfig hme0 192.1.0.3 netmask 255.255.255.0 up
Note
September 2005
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
This task sets up a Solaris workstation for a craft connection to the
ONS 15454.
None
NTP-G17 Set Up Computer for CTC, page 2-2
As needed
Onsite
None
If the interface is plumbed, a message similar to the following appears:
hme1:flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4>mtu 1500 index 2 inet
0.0.0.0 netmask 0
If a message similar to this one appears, go to
If the interface is not plumbed, a message similar to the following appears:
ifconfig: status: SIOCGLIFFLAGS: hme1: no such interface.
If a message similar to this one appears, go to
Enter an IP address that is identical to the ONS 15454 IP address except for the last octet. The
last octet must be 1 or 3 through 254.
DLP-G42 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454
Step 4.
Step 3.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
2-19