Dlp- G101 View Optical Channel Network Connection Information - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Create Channels and Circuits
•
•
Click the Circuits tab.
Step 2
If you are in node or card view, choose the scope for the search, Node or Network (All), in the Scope
Step 3
drop-down list located at the bottom right side of the screen. Choose Node to see all of the circuits on
that node, or Network (All) to see all circuits in the network.
Step 4 Click Search if you need to search through the list of circuits.
In the Circuit Name Search dialog box, complete the following:
Step 5
•
•
•
•
Click Find Next. If a match is found the circuit will be highlighted. To continue the search, click Find
Step 6
Next again to find the next circuit.
Repeat Steps
Step 7
Return to your originating procedure (NTP).
Step 8
DLP-G101 View Optical Channel Network Connection Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
•
•
September 2005
To search for circuits that originate, terminate, or pass through a specific node, choose View >
Go to Other Node, then choose the node you want to search and click OK.
To search for circuits that originate, terminate, or pass through a specific card, double-click the card
on the shelf graphic in node view to open the card in card view.
Find What—Enter the text of the circuit name you want to find.
Match whole word only—Check this check box to instruct CTC to select circuits only if the entire
word matches the text in the Find What field.
Match case—Check this check box to instruct CTC to select circuits only when the capitalization
matches the capitalization entered in the Find What field.
Direction—Choose the direction for the search. Searches are conducted up or down from the
currently selected circuit.
5 and 6 until you are finished, then click Cancel.
This task provides information about DWDM OCHNCs and ONS 15454
circuits.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
The following order is the default column sequence, the order might be different on your
Note
screen, depending on your individual CTC setup.
To view circuits for an entire network, choose View > Go to Network View.
To view circuits that originate, terminate, or pass through a specific node, choose View >
Go to Other Node, then choose the node you want to search and click OK.
DLP-G101 View Optical Channel Network Connection Information
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
7-3