Dlp- G297 Delete An Ip-Over-Clns Tunnel - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G297 Delete an IP-Over-CLNS Tunnel
DLP-G297 Delete an IP-Over-CLNS Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Deleting an IP-over-CLNS tunnel might cause the nodes to lose visibility or cause node isolation. If node
isolation occurs, onsite provisioning might be required to regain connectivity. Always confirm tunnel
deletions with your network administrator.
Click the Provisioning > OSI > Tunnels tabs.
Step 1
Choose the IP-over-CLNS tunnel that you want to delete.
Step 2
Click Delete.
Step 3
Click OK.
Step 4
Return to your originating procedure (NTP).
Step 5
NTP-G81 Change CTC Network Access
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Additional ONS 15454 networking information, including IP addressing examples, static route
Note
scenarios, OSPF protocol, and Routing Information Protocol (RIP) options are provided in
"Management Connectivity Reference."
Complete the
Step 1
Step 2.
Step 2 Complete the
Perform any of the following tasks as needed:
Step 3
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-18
This task allows you to delete an IP-over-CLNS tunnel.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
This procedure changes or deletes network information, including IP
settings, static routes, OSPF options, proxy tunnels, and firewall tunnels.
None
NTP-G26 Set Up CTC Network Access, page 3-11
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page
"NTP-G103 Back Up the Database" procedure on page
DLP-G162 Change IP Settings, page 10-19
DLP-G265 Lock Node Security, page 10-20
Chapter 10
2-25. If you are already logged in, continue with
13-2.
Manage the Node
Chapter 22,
September 2005