System Reset - Hitachi IJ RX2 Service Manual

2.8 System reset

et the set values on the "Printing data", "User pattern" and "Maintenance" screens to the values
●S
of initial condition.
●
Perform this function when the EZJ128 board or the EZJ126 board is replaced in a state allowing
no backup.
●
If this function is performed, perform setup and/or adjustment according to the contents described
in "3.2.4 EZJ128 board." and "3.3.1 EZJ126 board."
This setting is carried out with the IJ printer in "Stop" state.
●
1 The maintenance menu is displayed.
If Prev. menu Next menu is not displayed on the maintenance menu, set the service
personnel maintenance mode on the login user selection screen.
For information on changing to the service personnel maintenance mode,
refer to "2.1 Setting of service personnel maintenance mode."
2 Press System reset on the second page of the maintenance menu.
The confirmation message is then displayed.
241 = = = = =
The system will be reset.
This function is executed upon replacement of Board
EZJ128 or EZJ126.
OK
3 Press OK .
"Please wait" is displayed.
After the completion of the system reset, the screen returns to the service maintenance
screen.
System Reset Confirmation
2-25
= = = = =
Cancel