System Reset - Hitachi UX Twin Nozzle Service Manual

2.8 System reset

Reset the values on the "Printing data", "User pattern" and "Maintenance" screens to the initial
●
values..
●
Perform this function when the EZJ128 board or the EZJ133 board is replaced without backup.
●
If this function is performed, perform setup and/or adjustment according to the contents described
in "3.2.1 EZJ128 board" and "3.3.1 EZJ133 board".
This setting is carried out with the IJ printer in "Stop" state.
●
1 The maintenance menu is displayed.
If Prev. menu Next menu is not displayed on the maintenance menu, set the service
personnel maintenance mode on the login user selection screen.
For information on changing to the service personnel maintenance mode, refer
to "2.1 Setting of service personnel maintenance mode."
2 Press System reset on the second page of the maintenance menu.
The confirmation message is then displayed.
241 = = = = =
The system will be reset.
This function is executed upon replacement of Board
EZJ128 or EZJ133.
OK
3 Press OK .
"Please wait" is displayed.
After the completion of the system reset, turn the printer OFF and then back ON
after 10 seconds.
〔For work after System reset 〕
Please execute work according to [3.2.1 EZJ128 board (controller board) (12)-(13) of
replacement procedure].
Please execute work according to [3.3.1 EZJ133 board (MPU board) (12)-(13) of
replacement procedure].
System Reset Confirmation
2-27
= = = = =
Cancel