Makita RP2300FC Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Base complete
ASSEMBLING
Take the disassembling step in reverse.
Note: Set Compression spring 4 (2pcs.) in the groove on Base complete as illustrated in Fig. 6
M6 - Flat head screw is thread-locker type. When removing it, be sure to apply adhesive (ThreeBond 1321/ 1342
or Loctite 242) to the thread before reusing.
Assemble Compression spring 11, Compression spring 13, Pole and Silent pole as illustrated in Fig. 3.
Check that two Compression springs 4 work properly by pulling the lever portion of Lock plate after assembling
Base plate to Base. Refer to Figs. 6 and 4.
Fig. 6
1. Screw M5x10 Set bolt (2pcs.) to Base complete
Lock plate M5x10 Set bolt (2pcs.)
Compression
spring 4
[3]-2. Armature, Motor bracket complete
DISASSEMBLING
(1) Separate Base section from Motor section as illustrated in Figs. 2 and 3.
(2) Disassemble Armature as illustrated in Figs. 7, 8, 9, 10, 11, 12 and 13.
Fig. 7
Remove carbon brush and Collet nut.
Carbon brush
Collet nut
Fig. 8
Remove Cover by unscrewing 4x18 Tapping screw (2pcs.)
2. Set Compression spring 4 in place between the groove end of
Lever portion of Lock plate
Carbon brush
4x18 Tapping screw
(2pcs.)
Cover
Note: It is impossible to
disassemble Grip R
without removing
Cover.
Base complete and the hook of Lock plate.
Hook of Lock plate
Groove end of Base complete
M4x18 Pan head screw (2pcs.)
Retainer cover
Remove Grip cover (R) by unscrewing
4x18 Tapping screw (2pcs.)
Grip cover (R)
P 5/ 27
Remove Retainer cover by
unscrewing M4x18 Pan head
screw (2pcs.)
4x18 Tapping
screw (2pcs.)