Initial Value Change Of The Pm Motor Control Relations Parameter - Hitachi WJ200-001S Instruction Manual

Ver.3− − − − 22

Initial value change of the PM motor control relations parameter

I nitial value of the parameters listed below will be changed to appropriate values for PM motors when an
•
inverter mode is changed to PM mode.
Func. Func. Func. Func.
Code Code Code Code
b b b b 0 0 0 0 2 2 2 2 7 7 7 7
b b b b 0 0 0 0 8 8 8 8 3 3 3 3
b b b b 0 0 0 0 8 8 8 8 9 9 9 9
Name Name
Name Name
Overcurrent Suppression Selection
Carrier Frequency
Automatic Carrier Reduction
Initial data Initial data Initial data Initial data
Before Ver.3.0 Before Ver.3.0 Before Ver.3.0 Before Ver.3.0 After Ver.3.0 After Ver.3.0 After Ver.3.0 After Ver.3.0
01 00
2.0[kHz] 10.0[kHz]
01 00