Inverter Mode Selection - Hitachi WJ200-001S Instruction Manual

Ver.3− − − − 2

Inverter mode selection

C urrent mode of the inverter is displayed in d060.
•
I t changes to the PM mode by setting the initialization trigger (b180) to 01 after setting the inverter mode
•
selection (b171) to 03, and initialization is executed. Oppositely, it changes to the IM mode by setting the
initialization trigger (b180) to 01 after setting the inverter mode selection (b171) to 01, and initialization is
executed.
W hen changing inverter mode, observe the following precautions.
■
The Factory default is IM mode.
①
When inverter mode changing, b084 setting is not needed.
②
When PM mode, "Dual Rating Selection" is only "CT mode".
③
When 01 is set on the initialization trigger (b180), and SET key is pressed, initialization starts immediately
④
and there is not any way to restore the previous parameter setting.
All data will be initialized independent of b094.
⑤
The settings of "P100" to "P131", running-time data, and power-on time data cannot be cleared.
⑥
When display is restricted by the function code display restriction function (b037) or software is locked by
⑦
the software lock function (b031), you cannot initialize because the function codes of initialization are
no-display. If you forget password that restrict setting (b031) and (b037), you cannot cancel it. (So you
cannot initialize when software lock is active, you note that the setting password. (See section 7.6.11 the
password function.))
NOTE:. Parameters marked with " " in A column are accessible even in inverter running. NOTE
NOTE NOTE
Parameters marked with " " in B column are accessible even in inverter running when in the high level
access mode, which means that b031 is set to "10".
Func.
Code
b b b b 1 1 1 1 7 7 7 7 1 1 1 1 Inverter mode selection
b b b b 1 1 1 1 8 8 8 8 0 0 0 0 Initialization trigger
"b" Function "b" Function "b" Function "b" Function
Name Na Na Na me me me
00 00...Not change inverter mode 00 00
0 0 0 0 1 1 1 1 ...IM mode
0 0 0 0 2 2 2 2 ...Reserved
0 0 0 0 3 3 3 3 ...PM mode
No action
00... 00
00 00
Initialize
0 0 0 0 1 1 1 1 ...
Description Description Description Description
Run Run Run Run
Mode Mode Mode Mode Defaults Defaults Defaults Defaults
Edit Edit
Edit Edit
A A A A B B B B Initial data Initial data Initial data Initial data Units Units Units Units
00
-
00
-