Step 3 Changing Print Settings on the Printer Driver
If you still have misalignment problems after you follow the procedures in steps 1 and 2, you can adjust the image
position by changing the print job settings on the printer driver� The procedure below is for imagePRESS Server�
Printing One Page on One or Each Side of Paper
▀
For example, if the printing results are different from what you expected as shown below, use the following procedure
to change the settings� These settings can be changed for each job�
Front
What you wanted to print
1
Double-click the job in Command WorkStation on the imagePRESS Server�
• [Job Properties] is displayed�
2
Click the [Finishing] tab → select [Image shift] and enter the value in millimeters (inches) to
move the image horizontally (X direction) and vertically (Y direction)�
• In this case, enter the value for each direction as shown below�
[Front] X: 1�00 mm, Y: 2�00 mm
3
Click [Print]�
• The machine starts printing� Check the printed page and confirm that the misalignment problem is solved,
and then start printing�
86
86
imagePRESS C850/C750/C650/C65
Back
[Back] X: 2�00 mm, Y: 3�00 mm
2 mm
3 mm
Front
1 mm
What actually was printed
Back
2 mm