Honeywell OMNI 408 Installation And Setup Manual page 77

Entering Data
This section of the guide describes the physical keystrokes to enter the data written on the program
sheet.
System Program mode starts with question 1 displayed. Direct jumps to any question can be made by
pressing the [*] key and the 2-digit question number for system questions or by pressing the [*] key
followed by the [#] key and then the 2-digit question number for RF questions.
Questions can be accessed directly or sequentially.
Example: To jump to question 07, Press [*] [0] [7]
Movement from location 1 to the next location within any question can be performed by pressing the [#]
key. The data that will be changed by a key entry slowly blinks in the data area of the display.
To alter the value in any location, enter the desired digit from the program sheet, then press the [#]
key to advance to the next location, or if no further changes need to be made, press [Stay] to exit
programming.
NOTE: If an entry error was made and the [#] key was not yet pressed, re-enter the desired entry, then
press the [#] key to advance to the next program location or press [Stay] to exit programming.
Pressing the respective key on the keypad can perform numeric entries 0-9. Entries of A-F require 2
keystrokes, as follows:
Press the [Code] key followed by 1-6 keys for values A-F.
VALUE
A
B
C
Example: To enter an A, press the [Code] key followed by the [1] key.
The keypad chirps on each keystroke. In addition, a beep confirms advancement between question
numbers.
Four beeps signify an invalid input entry. After you make an invalid entry, the system positions you at
the same question number and location as immediately before you made the invalid entry.
Exit System Program Mode
After all programming has been completed, press the [Stay] key to exit the system Program mode.
Movement Between Questions
Movement Within Questions
Data Entry
KEYSTROKES VALUE
[Code] [1]
[Code] [2]
[Code] [3]
Question Acknowledgment
Section 9 - Data Entry Via Keypads
KEYSTROKES
D [Code] [4]
E [Code] [5]
F [Code] [6]
9–5