Honeywell OMNI 408 Installation And Setup Manual page 20

OMNI-408/OMNI-408EU Installation and Setup Guide
TO ARM: Enter any programmed 4-digit user code.
NOTE: The factory default for user 1 is 1234.
The ARMED LED will light and the user may exit through an exit/entry zone for the time period
programmed as the exit delay.
The system can be armed without the backup battery being connected; however, the AC/LB or BAT
light will flash depending on the keypad used.
Keypads will indicate the following message:
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC
LED Lit Armed
Display ON: AWAY; EXIT NOW
Arm While Faulted: If programmed (Question 07, Location 2), the user can arm the system while a
delay or interior zone is still faulted.
The Arm While Faulted feature must not be used for UL installations.
NOTE:
STAY ARMING
TO ARM: Press the [STAY] key followed by a 4-digit user code. This will arm the system with all
programmed interior zones excluded.
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC
LED Lit Armed
Display ON: STAY
INSTANT ARMING
TO ARM: Press the [INSTANT] key followed by a 4-digit user code. The INSTANT and ARM LEDs
will light continuously.
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC
LED Lit Armed
Display ON: INSTANT
The entire security system (interior and exterior) is armed at this time, eliminating the entry time
delay(s) that have been programmed into the system.
NOTE: The INSTANT mode can be enabled through Programming Question 10, L3.
STAY/INSTANT ARMING
TO ARM: Press the [STAY] key; press the [INSTANT] key, and enter a 4-digit user code.
The STAY/INSTANT mode will arm the system with the characteristics of both the STAY and
INSTANT modes. The keypads will have the ARM, INSTANT, and STAY LEDs ON continuously.
Indicator OMNI-LCD/OMNI-LCD-US/XK7LC
LED Lit Armed
Display ON: STAY/NS
4–6
OMNI-KP/OMNI-KP-US
Armed
n/a
OMNI-KP/OMNI-KP-US
Armed
STAY
OMNI-KP/OMNI-KP-US
Armed
INSTANT
OMNI-KP/OMNI-KP-US
Armed
INSTANT, STAY
XK108
Armed
n/a
XK108
Armed, Stay
n/a
XK108
Armed, Instant
n/a
XK108
Armed, Instant, Stay
n/a