Installing The Back Box - Cisco SCH-VDS-I Reference Manual

Installing the Back Box

Installing the Back Box
Note •
•
•
Figure 5
Warning Failure to ground the metal Back Box and Cisco Video Door Station faceplate properly can result in a
potentially hazardous condition.
Cisco Smart+Connected Video Door Station Reference Guide
14
Place the Back Box between studs. Do not attempt to install a Back Box over a wall stud.
If you are required to conform to NEMA safety standards, make sure you install a strain-relief cord
(sold separately) in the punchout on the Back Box before inserting the wires. See the
"Regulatory/Safety Information" section on page 37
http://www.nema.org/stds/
IMPORTANT! Make sure the Back Box protrudes far enough out (0.118" or 3 mm) from the exterior
wall surface (brick, rock, stucco, wood, concrete, etc.) to allow the plate and gasket to seal the Cisco
Video Door Station. See Figure
Back Box Side View in Wall with Cisco Video Door Station Faceplate
or the NEMA website at:
for details.
5.
OL-27367-01