Cisco Smart+Connected Reference Manual page 13

Configure the wireless settings (if not using Wi-Fi, skip to
Step 3
On the touchscreen, tap More > Settings > Network.
a.
Under Wireless, select Enable.
b.
If you don't see the network you want, select Other.
c.
At Network Name, select to add the SSID or name of the wireless network when the keyboard
d.
appears.
At Security, select None, WEP, or WPA.
e.
At Password, type the password given to you by the person who set up the wireless network.
f.
Select Connect. Notice that the IP settings change.
g.
The IP address is set to DHCP by default. If you need to set a static IP address, complete the following
Step 4
steps; otherwise, you are finished with these steps.
On the touchscreen, tap More > Settings > Network (if necessary).
a.
On the Network page, tap Static (see
b.
Figure 1-9
c. Select each field and use the keyboard to enter the IP Address, Subnet Mask, Default Gateway and
DNS server(s).
Tap Done when each field is complete.
d.
e. Tap OK to return to the Network page.
You can now connect to a Director (a Cisco Controller running on the network).
OL-27364-01
Figure
Static IP Address
Step 4).
1-9).
Cisco Smart+Connected Portable Tablet Reference Guide
Configuration
13