Portable Or Tabletop Installation Options; Using The Cisco Portable Tablet As A Portable Device - Cisco Smart+Connected Reference Manual

Portable or Tabletop Installation Options

The Cisco Portable Tablet can be used as a portable device, or attached (screwed) to the docking station.
Complete one of the following procedures:
•
•

Using the Cisco Portable Tablet as a Portable Device

Note You must set up for Wi-Fi if the Cisco Portable Tablet will be used as a portable device. See "Configure
the Network Settings."
Procedure
Place the docking station on a flat surface.
Step 1
Power the device using either a power cable or a Power over Ethernet (PoE) connection.
Step 2
a.
b.
c.
OL-27364-01
Using the Cisco Portable Tablet as a Portable Device, page
the docking station, you must use a Wi-Fi connection.
Using the Cisco Portable Tablet as a Tabletop Device, page
a tabletop, configure either an Ethernet or Wi-Fi connection and attach the device to the base using
the two (2) included screws.
Insert the power cable into the power jack slot on the back of the device (see
Plug the power cord into a wall outlet.
To use Ethernet, plug the RJ-45 connector into the PoE connector (such as a Cisco SF302-08P
Switch) and then into the Ethernet jack on the back of the docking station (see
Portable or Tabletop Installation Options
9—If the device will be removed from
10—If the device will ONLY be used as
Cisco Smart+Connected Portable Tablet Reference Guide
Figure 1-7).
Figure 1-7).
9