Connect To Director From The Cisco Portable Tablet - Cisco Smart+Connected Reference Manual

Configuration

Connect to Director from the Cisco Portable Tablet

The touchscreen's controls are auto-populated by a project on the Cisco Controller to which it connects.
Note
If the subsystem buttons are not lit, and no default room displays on the touchscreen, you are not
connected to a Cisco Controller. Ensure that the devices are added to Composer Pro and identified in the
project. See the
Procedure
On the Home page, tap More > Settings.
Step 1
Tap Director.
Step 2
If the Director page does not display, the Director view has probably been disabled; you must provide a
Step 3
password to enable it.
•
•
In the Director list of IP addresses, tap the Cisco Controller's IP address. The screen displays the current
Step 4
connections
Figure 1-10
Verify that the Name, IP Address, and default location (room) display on the Cisco Portable Tablet to
Step 5
ensure all of the correct connections.
Cisco Smart+Connected Portable Tablet Reference Guide
14
"Composer Pro Configuration" section on page 15
If you need the password, contact your Cisco reseller.
If you have the password, tap Config > Disable View, enter the password, and then tap Director to
deselect it. Tap the Director button again, and view the Director page.
(Figure 1-10).
Cisco Controller Address
for details.
OL-27364-01