Advertisement
Accessory user's information manual
Quick start guide
TOOLS AND SUPPLIES REQUIRED
Flat-tip screwdriver
Phillips screwdriver
Ratchet
8 mm and 10 mm Sockets
10 mm Open end wrench
Isopropyl alcohol
Shop towel
Ruler
Scissors
HDS/MVCI
Masking tape
Needle nose pliers
The following tools are available through the Honda Tool
and Equipment Program. On the iN, click on: Service >
Service Bay > Tool and Equipment Program, then enter
the number under "Search". Or, call 888-424-6857.
• Trim Tool Set (T/N SOJATP2014)
• Plastic Trim Tool (T/N SILTRIMTL10)
Illustration of the Engine Starter Installed on the
Vehicle
2 RELAYS
CONTROL
UNIT
2 of 20
ANTENNA
ENGINE START-
ER HARNESS
3A FUSE
QC61801AG
40A FUSE
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE: This antenna should only be installed if the
ambient air temperature is 15°C (60°F) or above.
1.
Disconnect the negative cable from the battery.
2.
Attach the ID label.
•
Using isopropyl alcohol on a shop towel, clean
the area where the ID label will attach.
•
Attach the ID label to the transmitter in the area
as shown.
TRANSMITTER
AII 51572 (1405)
ID LABEL
Clean with
isopropyl
alcohol.
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
QBD0601AE
Advertisement
