Advertisement
61. Using isopropyl on a shop towel, thoroughly clean
the hood where the caution label will attach.
Clean with
isopropyl alcohol.
CAUTION
LABEL
ADHESIVE
BACKING
(Remove.)
62. Remove the adhesive backing from the caution label,
and attach the caution label to the hood in the area
shown.
63. Check that all wire harnesses are routed properly
and all connectors are plugged in.
64. Check the overlap between the headliner and the
driver's A-pillar trim. Refer to the Service Manual if
adjustments are necessary.
65. Reinstall all removed parts. Make sure the airbag is
not pinched by the trim.
66. Reconnect the negative cable to the battery.
67. Check the operation of the headlights and wipers.
68. Reset the clock on vehicle without navigation.
69. Perform the "REMOTE ENGINE STARTER
REGISTRATION" and the "Check the operation of
the Remote Control Engine Starter."
16 of 20
HOOD
7D0702AE
REMOTE ENGINE STARTER REGISTRATION
NOTE: Register after making sure the HDS has been
upgraded to the latest version as described in the Service
News.
1.
Acquire the PCM Code from the Interactive Network.
2.
Connect the HDS/MVCI tester to the OBD II data link
connector, then turn the ignition switch to the ON (II)
position.
3.
Start the HDS, and click the car icon.
4.
Input the VIN and other required information into the
HDS, then click the check button.
Input the VIN and other
required information.
5.
Select Honda Systems, then click the check button.
AII 51572 (1405)
CAR ICON
CHECK BUTTON
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
QC31909AC
QB32102BH
Advertisement
