Starter Cut Relay; Verification Of Signal Relay Giro - Yamaha FZ-16 Service Manual

Starter cut relay

2
1. Positive battery terminal
2. Negative battery terminal
3. Tester positive probe
4. Tester negative probe
Result
Continuity
(Between "1" and "3")
VERIFICATION OF SIGNAL RELAY
GIRO
1. Check:
• Input voltage relay turn signal
Off-specification circuit from the
switch to the relay coupler
turn signal is defective and must be
repaired.
Input voltage of the relay
Turn signal 12 V DC
a. Connect the multimeter to the relay terminal
turn signal, as shown.
Multimeter
• Tester positive probe
coffee "1"
• Tester negative probe
land
1
3
LB RB
RW
Br/W
Br
1
ELECTRICAL COMPONENTS
b. Turn the main switch to "ON".
c. Measuring the input voltage signal relay
of rotation.
Output voltage relay
Turn signal 12 V DC
2. Check:
• The output voltage relay turn signal.
Replace out of specification.
a. Connect the multimeter to the relay terminal
turn signal, as shown.
Multimeter
• Tester positive probe
brown / white "1"
• Tester negative probe
land
b. Turn the switch to "ON".
c. Measuring the output voltage signal relay
of rotation.
7-38
1
Br/W
Br