Disassembly Of Lower Bracket; Checking The Address Column; Fitting The Steering Column - Yamaha FZ-16 Service Manual

DISASSEMBLY OF LOWER BRACKET

1.
I placed the vehicle on a flat surface
WARNING
Support the vehicle with safety to
there is no risk of falling.
2. Disassembly:
•
Upper ring nut
•
Rubber washer
• Lower ring nut "1"
Bottom bracket "2"
•
NOTE:
Disassemble the lower ring nut with the wrench
direction to the nut "2".
Nut wrench direction
YSST-721
WARNING
Secure the bottom bracket securely
so there is no risk of falling.
2
CHECKING THE COLUMN
ADDRESS
1.
Wash:
•
Bearings
•
Bearing races
Solvent for cleaning
recommended
Kerosene
2.
Check:
•
Bearings
•
Bearing races
Damage / pitting Replace.
3.
Replace:
•
Bearings
•
Bearing races
a.
Remove the bearing races of the tube
of the steering column with a rod
long "1" and the hammer.
STEERING
b.
Remove the lower bearing support
chisel "2" and the hammer.
c.
Install the bearing races and a new
overall.
CAUTION
If the bearing races are not
installed correctly, it could damage the
tube of the steering column.
NOTE:
•
Always replace bearings and tracks
Bearing as a whole.
•
Each time you remove the column
1dirección, replace the dust.
1
4.
Check:
•
Upper Bracket
•
Bottom Bracket
(Together with the stem of the address)
Curves / cracks / damage Replace.

FITTING THE STEERING COLUMN

1.
Lubricate:
•
Upper bearing
•
Lower bearing
•
Bearing races
2.
Assemble:
•
Lower ring nut
•
rubber washer
4-45
Recommended lubricant
Based grease lithium soap