done_timer
state
fast_done
Restrictions
You must have administrator privileges.
Example
To configure MLD snooping:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g m l d _ s n o o p i n g d e f a u l t n o d e _ t i m e o u t 2 5 0 s t a t e e n a b l e
C o m m a n d : c o n f i g m l d _ s n o o p i n g d e f a u l t n o d e _ t i m e o u t 2 5 0 s t a t e e n a b l e
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #
33-2 config mld_snooping querier
Purpose
Used to configure the time in seconds between general query transmissions, the maximum time in
seconds to wait for reports from listeners, the permitted packet loss that guarantees MLD snooping.
Format
config mld_snooping querier [ <vlan_name 32>| vlanid <vlanid_list>| |all] { query_interval <sec
1-65535> | max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_listener_query_interval <sec 1-25> | state [enable|disable] | version <value 1-2> }
Description
The config mld_snooping querier command configures MLD snooping querier.
Parameters
Parameters
vlan_name
query_interval
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
The done timer. The default setting is 2.
enable or disable MLD snooping for the chosen VLAN.
enable or disable the MLD snooping fast done function. If enabled,
the membership is immediately removed when the system receives
the MLD done message.
Description
The name of the VLAN for which MLD snooping querier is to be
configured.
Specifies the amount of time in seconds between general query
transmissions. The default setting is 125 seconds.
247