Enable Address_Binding Acl_Mode - D-Link DGS-3200 SERIES Cli Manual

D G S - 3 2 0 0 - 1 0 : 4#show address_binding ip_mac
Command: show address_binding ip_mac
ACL_mode : Disabled
Trap/Log : Disabled
Enabled Ports:
Enabled Allow Zero IP Ports:
IP Address MAC Address
--------------- ----------------- ---- ------------------------------
10.90.90.1 00-11-22-33-44-55 ARP
10.90.90.2 00-11-22-33-44-55 ARP
Total Entries : 2DGS-3200-10:4#

39-6 enable address_binding acl_mode

Purpose
To enable the address binding ACL mode.
Format
enable address_binding acl_mode
Description
User uses this command to enter the address binding ACL mode.
If a user enables the ACL mode, the switch will first check if there are existing two empty access profiles. If
the switch does not have two empty access profiles, it will show an error message and can not enable the
ACL mode; Otherwise the switch will create two access profiles automatically.
After enabling the ACL mode, the switch will check if there are any ports with address binding enabled. If
this port is address binding enabled, the switch will create an access entry automatically (To block all IP
packets on this port). If the ACL pool is full and the switch can not create access entries, the switch will
return a warning message.
If a user already created some address binding entries, then enable the address binding ACL mode. The
switch will automatically create access entries (Each entry which has a mode belonging to ACL in the
address binding entries).
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Mode Ports
2
1-16
337