Config Link_Aggregation Algorithm - D-Link DGS-3200 SERIES Cli Manual

Parameters
Parameters
group_id
master_port
ports
state
Restrictions
You must have administrator privileges.
Example
To define a load-sharing group of ports, group-id 1, master port 7:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g l i n k _ a g g r e g a t i o n g r o u p _ i d 1 m a s t e r _ p o r t 7 p o r t s 5 - 7
C o m m a n d : c o n f i g l i n k _ a g g r e g a t i o n g r o u p _ i d 1 m a s t e r _ p o r t 7 p o r t s 5 - 7
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

22-4 config link_aggregation algorithm

Purpose
Used to configure the link aggregation algorithm.
Format
config link_aggregation algorithm [mac_source_dest | ip_source_dest]
Description
The config link_aggregation algorithm command configures the part of the packet examined by the
switch when selecting the egress port for transmitting load-sharing data. This feature is only available when
using the address-based load-sharing algorithm.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specifies the group ID. The group number identifies each of the
groups. The switch allows up to five link aggregation groups to be
configured.
The master port ID. Specifies which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master
port.
Specifies a range of ports that will belong to the link aggregation
group.
Allows you to enable or disable the specified link aggregation group. If
configuring an LACP group, the ports' state machine will start.
193