DGS-1250 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide
This example shows how to execute the "Config2" file in the NVRAM immediately by using the increment method.
Switch#copy flash: Config2 running-config
Source filename [Config2]?
Destination filename running-config? [y/n]:
Executing script file Config2 ......
Executing done
Switch#
This example shows how to download an image file from the TFTP server.
Switch#copy tftp: //10.1.1.254/runtime.had flash: Image1
Address of remote host [10.1.1.254]?
Source filename [runtime.had]?
Accessing tftp://10.1.1.254/runtime.had...
Transmission start...
Transmission finished, file length 8713712 bytes.
Please wait, programming flash.............. 100 %
Please wait, programming flash for language files .............Done.
Switch#
2-2
boot config
This command is used to specify the file that will be used as the configuration file for the next boot.
boot config {Config1 | Config2}
Parameters
Config1
Config2
Default
By default, Config1 is used.
Command Mode
Global Configuration Mode.
Usage Guideline
The command is used to specify the startup configuration file. If there is no valid configuration file, the device will
be configured to the default state.
y
Specifies to use Config1 as the startup configuration file.
Specifies to use Config2 as the startup configuration file.
8