Snmpv3 Command List; Create Snmp User - D-Link DGS-3200 SERIES Cli Manual

6 SNMPv3 Command List

create snmp user <SNMP_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16 > | sha <auth_password 8-20 >]
priv [none | des <priv_password 8-16> ]|
by_key auth [md5 <auth_key 32-32>| sha <auth_key 40-40>]
priv [none | des) <priv_key 32-32> ]]}
delete snmp user <SNMP_name 32>
show snmp user
show snmp groups
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 32> [all | <oid>]
show snmp view {<view_name 32>}
create snmp community <community_string 32> view <view_name 32> [read_only|read_write]
delete snmp community <community_string 32>
show snmp community { <community_string 32> }
config snmp engineID <snmp_engineID 10-64>
show snmp engineID
create snmp group <groupname 32> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]]{read_view <view_name 32> | write_view <view_name 32> | notify_view <view_name
32>}
delete snmp group <groupname 32>
create snmp [host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv] ] <auth_string 32>
delete snmp [host <ipaddr> | v6host <ipv6addr>]
show snmp v6host { <ipv6addr> }
show snmp host { <ipaddr> }
show snmp traps
Note: If SNMPv3 commands are used, SNMPv1/v2 commands are not necessary.

6-1 create snmp user

Purpose
Used to create a new user to an SNMP group originated by this command.
Format
create snmp user <SNMP_name 32> <groupname 32> {encrypted(1)
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
63