2. Setting the developer unit
(1) Remove the part fastening the lens unit
from the machine.
•
Push it to the rear side and lower it si-
multaneously to remove it.
(2) Take out the process unit (1 screw).
(3) Remove the developer unit spacer from the
process unit.
(4) Place the process unit on a flat surface.
Raise the lever located on each side of the
process unit in the direction of the arrow.
(5) Pull out one connector.
(6) Take out the developer unit from the proc-
ess unit.
Note: If the photoconductor is exposed to
fluorescent light or external light for
long time, it may suffer from light-
caused fatigue. So, be sure to cover
the process unit with, for example, a
suitable cloth.
Mar. 1998 © TOSHIBA
1
2
18 - 3
1550/1560 UNPACKING PROCEDURE
Spacer
Developer unit
Spacer
Lever
Developer unit
Lever
Connector