Wiring The Module For Two-Way Voice; Mounting The Module On The Wall - Honeywell CDMA-X Installation And Setup Manual

4. Connect the ECP cable to the communicator circuit board and thread the wires through the threaded mounting
adapter.
5. Refer to the control panel's installation guide, and complete the ECP cable wiring.
6. Secure the wiring with ties as necessary.

Wiring the Module for two-way voice

The CDMA-X requires an optional audio cable (GSMX-AUDIO, black) to support two-way voice using the AVS Base
Unit. Note the AVS Base Unit is part of Honeywell's AVS Audio Verification System. This system consist of the AVS
Base Unit, Remote Station, and the Remote Station PC board. For detailed information, please refer to the AVS
Audio Verification System documentation. Follow the guidelines below for connecting the audio cable.
1. Power down the communicator, control panel and AVS Audio Verification System. (When the communicator is
fully wired up, restore power to the communicator, control panel and AVS Audio Verification System.)
2. Connect one end of the audio cable (5-pin connector) to the audio connector located on the PC board in the
communicator.
3. Route the audio cable to the connector on the AVS Base Unit and connect the cable (4-pin connector).
4. Ensure the audio cable ends are secured with tie wraps to reduce strain.
NOTE: For compliance agency, CDMA-X and AVS must be located in the same room or within 3 feet of one another.

Mounting the Module on the Wall

1. Ensure control panel power (both AC and battery) is off, then remove a suitable knockout on the top or side of the
control panel cabinet.
NOTES:
• If in the wall wiring will be used, route the wiring through the communicator's rear wiring access hole.
• If surface mounted wiring will be used, remove the communicator's bottom knockout and use that to route the
wiring.
• If using two-way voice, refer to the previous topic.
2. Open the communicator's cover. Remove the external antenna port cap attached to the plastic (trim as
necessary), and snap it into the external antenna cable port at the top of the enclosure.
3. Secure the enclosure to the wall using both mounting holes.
CDMA-X Installation and Setup Guide
– 5 –