Honeywell CDMA-X Installation And Setup Manual page 14

PROMPTS
22
Telco Zone
(0)_
23
Open/
Close Zone (0)
24
Restore Zn1 Y/N
(Y)
25
Delay Zn1 (secs)
(00)
26
Rpt Zn1 ONLY if
Armed
(N)
27
Restore Zn2 Y/N
(Y)
28
Delay Zn2 (secs)
(00)
29
Rpt Zn2 ONLY if
Armed
(N)
30
Restore Zn3 Y/N
(Y)
31
Delay Zn3 (secs)
(00)
CDMA-X Installation and Setup Guide
ENTRY OPTIONS
only
4204: [1-4]
4204
2-4204:
2-4204
[1-8]
[0] = not used
only
4204: [1-4]
4204
2-4204:
2-4204
[1-8]
[0] = not used
only [Y], [N]
4204
2-4204
[01-15]
only
4204
[00] = no delay
2-4204
[Y], [N]
only
4204
2-4204
only [Y], [N]
4204
2-4204
[01-15]
only
4204
[00] = no delay
2-4204
only [Y], [N]
4204
2-4204
only [Y], [N]
4204
2-4204
[01-15]
only
4204
[00] = no delay
2-4204
See "Important Information Regarding Zone Input
Options" on previous page.
Enter the zone number to be used for Telco line fault
reports. This zone assignment must be unique from
the open/close zone selected in Prompt 23.
4204 Mode: If any zone is programmed for "report
only if armed," zone 4 cannot be used as a Telco
zone.
2-4204 Mode: If any zone is programmed for "report
only if armed," zone 8 cannot be used.
NOTE: Connect the Telco line fault output (or relay
output programmed for "Telco line fault") to the Telco
zone.
Enter the zone number to be used for open/close
(arm/disarm) reports. This zone assignment must be
unique from the Telco zone selected in Prompt 22.
4204 Mode: If any zone is programmed for "report
only if armed," zone 4 cannot be used as an
open/close zone.
2-4204 Mode: If any zone is programmed for "report
only if armed," zone 8 cannot be used.
NOTE: Connect an open/close (arm/disarm) trigger (or
relay output) from the control panel to the open/close
zone.
Enables restore reporting for
zone 1.
Defines the reporting delay in seconds for zone 1.
Reports alarms on zone 1 ONLY if the conditional zone
(zone 4 in 4204 mode; or zone 8 in 2-4204 mode) is
triggered (armed).
If [N], always reports alarms on zone 1.
Enables restore reporting for
zone 2.
Defines the reporting delay in seconds for zone 2.
Reports alarms on zone 2 ONLY if the conditional zone
(zone 4 in 4204 mode; or zone 8 in 2-4204 mode) is
triggered (armed).
If [N], always reports alarms on zone 2.
Enables restore reporting for
zone 3.
Defines the reporting delay in seconds for zone 3.
– 12 –
DESCRIPTION