Makita JV0600 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Crank Mechanism
ASSEMBLING
(1) Assemble Armature to Bearing case complete. Refer to the lower illustrations in Fig. 6.
(2) Assemble Crank mechanism as drawn in Fig. 7.
Fig. 7
1. Mount Push plate, Balance plate, Gear complete and
Flat washer 6 to Bearing case complete. And push
Gear complete toward Bearing case complete to
reserve the groove for assembling Retaining ring S-6.
Bearing case complete
3. Assemble Needle gauge 407 and Sleeve 7 to crank pin of Gear complete, facing the brim
of sleeve 7 to Gear complete side. And mount Flat washer 10.
(3) Referring to Fig. 5, mount the assembled Crank mechanism to Housing set (L).
(4) Make sure that O ring 5 is mounted to the accepting hole for Slider guide respectively before assembling slider section.
See Fig. 8.
Fig. 8
Housing set (R)
Push plate
Balance plate
Gear complete
Flat washer 6
Needle gauge 407
Sleeve 7
Flat washer 10
Housing set (L)
O ring 5
2. Mount retaining ring S-6 to the pin of
Bearing case complete.
Now, Gear complete, Balance plate,
and push plate are secured to Bearing
case complete.
Bearing case complete
Retaining ring S-6
P 6/ 12