Operation - Makita HM1214C Instruction Manual

Side handle (auxiliary handle)
1
2
009977
The side handle can be swung 360° on the vertical and
secured at any desired position. It also secures at eight
different positions back and forth on the horizontal. Just
loosen the clamp nut to swing the side handle to a
desired position. Then tighten the clamp nut securely.
Installing or removing the bit
1
009664
Clean the bit shank and apply bit grease before installing
the bit.
Insert the bit into the tool. Turn the bit and push it in until it
engages.
2
009973
If the bit cannot be pushed in, remove the bit. Pull the
releasing cover down a couple of times. Then insert the
bit again. Turn the bit and push it in until it engages.
010077
1. Side handle
2. Clamp nut
1. Bit shank
2. Bit grease
2
1. Releasing cover
2. Bit
1
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the releasing cover down all the
way and pull the bit out.
009974
Bit angle
009975
The bit can be secured at 12 different angles. To change
the bit angle, slide the change ring cover forward, then
turn the change ring cover to change the bit angle. At the
desired angle, slide the change ring cover back to the
original position. The bit will be secured in place.

OPERATION

Chipping/Scaling/Demolition
009980
Always use the side grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations. Turn the tool on and apply slight pressure on
the tool so that the tool will not bounce around,
uncontrolled. Pressing very hard on the tool will not
increase the efficiency.
6
1. Releasing cover
1
1. Change ring
1
cover