User Programming Functions - Honeywell GKP-S8M User Manual

User Programming functions

Important: The system will automatically exit the
programming mode after 20 seconds if no keys are
pressed during this time. When this happens you must
repeat all of the steps necessary for the function you are
using.
The keypad features 2 programming modes:
- User Programming mode to adjust beep level,
enable/disable the chime.
- Master User Programming mode to manage user profiles
(the keypad can have up to 10 user profiles configured). This
mode can only be accessed with the master code (master user
#1).
USER FUNCTIONS
To adjust the volume of the beep:
1. Press and hold the
than 2 seconds to enter user programming mode.
A double beep is played and all LED light on.
2. Keep pressing the
to adjust (each device will emit a beep when it is selected).
Example: If you want to adjust the beep level for device 2:
press the
its selection.
All LEDs start flashing.
3. Press a key from
(1 = min, 7 = max).
The device selected will emit a beep at the new level to
confirm the beep volume.
4. Press the
you changes.
8
and
key to select the device that you wish
key twice. Device 2 will emit a beep to confirm
to to select the required beep volume
key to exit user programming mode and save
keys simultaneously more