Arming With A Fault (*); Disarming Using Your Code Or Tag - Honeywell GKP-S8M User Manual

Arming with a fault
If the system diagnoses a fault on arming, you cannot set the
alarm. Faults include system faults, tampering and triggering of
detectors.
A tone indicating a fault is emitted by the keypad after the arming
request instead of the arming tone.
Check that all doors and windows fitted with contacts are closed.
You can override prevention of arming by requesting arming a
second time within two minutes from the first request. This will
bypass all faults.
The arming process restarts, the arming tone is emitted by the
keypad followed by the exit delay beeps. Arming is completed at
the end of the delay.
(*) If keypad installed with CMI, HMI, Sucre Box panels. Refer to Annex A if keypad installed
with PMI panels.

Disarming using your code or tag

To enable you to get to the keypad without triggering an alarm,
your installer may have programmed an entry delay.
To disarm your system:
Enter a valid code or present a programmed TAG.
The disarming tone is emitted by the panel and keypad siren.
Disarming the system will also stop the sirens if an alarm is
triggered.
Important: Stopping the siren does not interrupt the
transmission of the alarm to the alarm company.
Notes:
Always make sure that your disarming request is followed by
the disarming tone.
Always disarm the system when re-entering the premises.
Holding the TAG in front of the keypad will not reverse the
status.
(*)
5